Two forces, 1 and 2, act on the 5.00 kg block shown in the drawing. The magnitudes of the forces are F1 = 49.0 N and F2 = 44.
November 21, 2020
Short Paper on Sales Management
November 21, 2020

Two slitting rolls A and B for cutting sheet metal are driven by means of the gear train shown in Fig. The rolls must operate in the direction shown…

Two slitting rolls A and B for cutting sheet metal are driven by means of the gear train shown in Fig. 7.22. The rolls must operate in the direction shown at a peripheral speed of 1150 mm/s. (a) Determine the angular velocity ratio W2/W3 to drive the rolls at the required speed. Gear 1 runs at 1800 rpm. (b) Determine the direction of rotation of gear 1 and the hand of worm 6 to give the required rotation of the rolls.

The post Two slitting rolls A and B for cutting sheet metal are driven by means of the gear train shown in Fig. The rolls must operate in the direction shown… first appeared on https://nursingassignmenttutor.com.


Two slitting rolls A and B for cutting sheet metal are driven by means of the gear train shown in Fig. The rolls must operate in the direction shown… was first posted on November 21, 2020 at 7:21 am.
©2019 "Submit Your Assignment". Use of this feed is for personal non-commercial use only. If you are not reading this article in your feed reader, then the site is guilty of copyright infringement. Please contact me at [email protected]

 

"Are you looking for this answer? We can Help click Order Now"